STM-3.com

STM-3â„¢ Metal Treatment Dosage

1 cylinder -  add 1 capfull of STM-3™ to warmed up engine. Restart immediately and run for 1/2 hour minimum.

2 cylinder - add 2 capfuls of STM-3â„¢ to warmed up engine. Restart immediately and run for 1/2 hour minimum.

 2 Cycle - add 1 capful to fuel tank (mix well) and operate immediately, then 1 capful for every 1 gallon of fuel (3.75 liters). NOTE: CermaGuard does NOT replace 2 cycle oil !!! but mixes with fuel.  Tip :  Add a few drops on the bar and chain oil of your chainsaw, restart and use immediately - Awesome !

Note: New engines should be broken in prior to adding STM-3â„¢ to allow rings to seat in quicker.