STM-3.com

STM-3™ Metal Treatment Dosage

Note: (Treating the entire unit will result in reduction of friction and wear and help to achieve maximum overall efficiency and protection.)

Diesel Pickup Trucks

Engine - 4 cylinder: add 4 oz.(118 ml) of STM-3™. 6-8 cylinder: add 6 oz. (177 ml) of STM-3™

Transmission - Automatic: add 1 oz. (29 ml) of STM-3™.  Standard: add 2 oz. (59 ml) of STM-3™

Power Steering - add 1 oz. (29 ml) of STM-3™

Differentials - add 2 oz. (59 ml) of STM-3™

Transfer Cases - add 2 oz. (59 ml) of STM-3™

Diesel Semi Trucks

Engine - add 16 oz. (473 ml) of STM-3™ *Required (note: additional STM-3™ may be required after one million miles (1,600,000 kilometers) of being treated with STM-3™)

Automatic Transmission  -  2 oz. (59 ml)  *Recommended

Manual Transmission -    6 oz. (177 ml)  *Recommended

Differentials -  8 oz. (237 ml)  *Recommended

Wet axle -  1 oz. (30 ml)  per axle *Recommended

1- Warm up engine, ensure vehicle is in park or neutral with parking brake on and  wheels blocked.

2- If possible add product with engine running, if blow by is present shut engine off, add product and immediately start engine after adding product,bring your engines rpm's up to 1500-2000 RPM and hold for 2-3 minutes. This procedure will ensure that STM-3™ treats the entire engine, as STM-3™ does not mix with your oil ! The oil is only a carrier of the product as the oil is circulated STM-3™ will impregnate the metal. Now continue to run engine for no less than 2 hours,     
Preferred method is to drive the vehicle for approximately 150-500 kilometers or for a full day trip. For best results. (Do Not Shut Engine Off) For at Least 2-4 Hours after adding STM-3™ to your oil.

None